glenda.party
term% ls -F
term% pwd
$home/manuals/unix_v8/1/stty
term% cat index.txt
STTY(1)                     General Commands Manual                    STTY(1)



NAME
       stty - set terminal options

SYNOPSIS
       stty [ option ... ]

DESCRIPTION
       Stty  sets  certain I/O options for the terminal open on /dev/tty (file
       descriptor 3).  With no argument, it reports the  current  settings  of
       the options.  The options are:

       even      allow even parity
       -even     disallow even parity
       odd       allow odd parity
       -odd      disallow odd parity
       raw       raw  mode input (no erase, kill, interrupt, quit, EOT; parity
                 bit passed back)
       -raw      negate raw mode
       cooked    same as `-raw'
       cbreak    make each character available  to  read(2)  as  received;  no
                 erase and kill
       -cbreak   make  characters  available  to read only when newline is re‐
                 ceived
       -nl       allow carriage return for new-line, and output CR-LF for car‐
                 riage return or new-line
       nl        accept only new-line to end lines
       echo      echo back every character typed
       -echo     do not echo characters
       lcase     map upper case to lower case
       -lcase    do not map case
       -tabs     replace tabs by spaces when printing
       tabs      preserve tabs
       ek        reset erase and kill characters back to normal # and @
       erase c   set  erase  character  to c (initially `#') In this and other
                 character-setting options a `^' may precede c to signify con‐
                 trol-c.
       kill c    set kill character to c (initially `@')
       intr c    set interrupt character to c (initially DEL)
       quit c    set quit character to c (initially `^\')
       stop c    set stop character to c (initially `^S')
       start c   set start character to c (initially `^Q')
       eof c     set `end of file' character to c (initially `^D')
       brk c     set `line-break' character to c (initially undefined)
       cr0 cr1 cr2 cr3
                 select style of delay for carriage return (see ioctl(2))
       nl0 nl1 nl2 nl3
                 select style of delay for linefeed
       tab0 tab1 tab2 tab3
                 select style of delay for tab
       ff0 ff1   select style of delay for form feed
       bs0 bs1   select style of delay for backspace
       tty33     set  all modes suitable for the Teletype Corporation Model 33
                 terminal.
       tty37     set all modes suitable for the Teletype Corporation Model  37
                 terminal.
       vt05      set  all modes suitable for Digital Equipment Corp. VT05 ter‐
                 minal
       tn300     set all modes suitable for a General Electric TermiNet 300
       ti700     set all modes suitable for Texas Instruments 700 series  ter‐
                 minal
       tek       set all modes suitable for Tektronix 4014 terminal
       hup       hang up dataphone on last close.
       -hup      do not hang up dataphone on last close.
       0         hang up phone line immediately
       50 75 110 134 150 200 300 600 1200 1800 2400 4800 9600 exta extb
                 Set terminal baud rate to the number given, if possible.

SEE ALSO
       ttyld(4), ioctl(2), tabs(1)



                                                                       STTY(1)